You don't need tools for any of this. The point is to catch a worn cable, a weak sensor or a door that no longer reverses before it turns into a stuck car or an injury.
What Short Hills homes are up against
Short Hills was laid out with each house on its own knoll, and many garages still sit at the top or the bottom of a sloped drive on a wooded lot. Slopes send water and leaves toward the door, so the bottom seal and the track bases need a look every fall. Clear the debris, wipe the photo-eye lenses, and watch the door close once from inside. Daylight under one corner means it is time for an adjustment.
The Tudors and Colonials in Old Short Hills and the Park historic district often have wood or wood-overlay doors chosen to suit the house. They are heavier than plain steel, and they gain weight when the finish fails and the wood takes on water. If a door that used to stay put at waist height now sinks, the springs are no longer matched to it. Stop using the opener and have the balance checked.
Every month
- Listen: grinding, scraping or a new bang on every cycle usually means a worn roller, a dry hinge or a spring near the end of its life.
- Check the wall button is mounted high enough that small children can't reach it, and keep remotes out of their reach too.
- Photo-eye test: start closing the door and wave a broom handle through the beam near the floor. The door should stop and reverse.
- Reverse test: lay a roll of paper towels flat under the door and close it. The door should touch it and go back up. If it doesn't, stop using the opener until it's adjusted.
- Balance check: pull the red release cord with the door closed and lift it by hand to waist height. A balanced door stays put; one that drops or shoots up has a spring problem.
Before winter
- Clean the photo-eye lenses; condensation and grime are a common cause of doors that refuse to close.
- Check the rubber seal along the bottom of the door. If you see daylight underneath, a new seal keeps out snow, water and mice.
- Note where the manual release cord is and practise using it once while the door is closed.
- Move anything stored near the door tracks or springs so it can't snag the moving parts.
During cold weather
- Keep the area under the door clear of ice ridges so the door can seal and the reverse system isn't fooled.
- Give the opener a moment if it strains on the first cold run; repeated straining can wear out the drive gear.
- Expect springs to break more often in a cold snap. A loud bang from the garage on a frigid morning is usually a spring.
Spring and summer
- Tighten loose bolts on hinges and brackets with a socket wrench, except anything attached to the springs or the bottom corner brackets.
- Test the reverse and photo-eye again after any work on the door or opener.
- Wash the door and check painted wood or steel for peeling and rust spots before they spread.
Stop using the door and call if
- A loud bang, then a door that won't lift: a spring has broken.
- A cable hanging loose or a door hanging crooked.
- A roller out of its track or a door stuck partway.
- The door fails the reverse test.
- Visible gaps or cracks in a spring.
Never
- Never adjust, loosen or remove springs, cables or the bottom brackets yourself; they hold the door's full weight under tension.
- Never walk or let children run under a moving door.
- Never keep using the opener on a door that's crooked or heavy; it will strip the gears or pull the door off its track.